automeasuring
-
Auto measuring module allows to check in real-time, based on defined parameters, movements of fixed targets.
-
Reference points are measured from a known station to verify their position.
-
A scale factor is then applied to correct the measured distances.
-
The measurement of reference points is performed automatically following a defined sequence.
-
At the end of the measurement session, a report is generated. For each measured point, the deviations recorded during each session are listed.
-
If issues are detected during the measurement sessions, notifications can be sent.
-
This chapter covers the following topics:
-
Auto Measuring settings: learn how to change the aapplication settings to select how to perform the automatic measuring task and transmit the data.
-
Definition of control points and points to measure: learn how to define the control points and the points to measure and their properties.
-
Automatic measuring: learn how to perform an automatic measuring session.
-
Auto Measuring report: learn how to generate report.
-
Single measuring: learn how to perform a single measuring session.
-
Activity log: learn how to visualize and export the activity log.
-